Trouble Recovery
89
5. Unscrew the filter cup from the filter
housing. NOTICE: Be careful not to
twist the water detection switch lead
when unscrewing the filter cup.
[ECM01961]
6. Drain the water in the filter cup by soak-
ing it up with a rag.
7. Firmly screw the filter cup onto the filter
housing. NOTICE: Be careful not to
twist the water detection switch lead
when screwing the filter cup onto the
filter housing.
[ECM01971]
8. Connect the water detection switch cou-
pler securely until a click is heard.
9. Fasten the water detection switch lead
with the holder.
10. Install the top cowling.
11. Place the remote control lever in neutral
and turn the main switch to “ ”(on).
Make sure that the buzzer does not
sound, or start the engine and make sure
that the water separator-alert indicator
remains off. Have a Yamaha dealer in-
spect the outboard motor after returning
to port.
EMU33502
Treatment of submerged motor
If the outboard motor is submerged, immedi-
ately take it to a Yamaha dealer. Otherwise
some corrosion may begin almost immedi-
ately. NOTICE: Do not attempt to run the
outboard motor until it has been com-
pletely inspected.
[ECM00402]
1. Filter cup
2. Water detection switch lead
1. Water detection switch coupler
1. Holder
U63P7KE0.book Page 89 Wednesday, November 29, 2017 11:06 AM
To Next Page
Loading...
