Yamaha PC4002 - Rear Panel; Speaker Terminals (For Each Channel); Ground Lift Switch (For Each Channel); Input Connectors (XLR-3-31)

REAR PANEL
Cord Reel
6) SPEAKER TERMINALS (FOR EACH CHANNEL)
The red speaker terminal should be connected to the “+”
terminal of the speaker system, and the black terminal to
the “-” channel. (In the above illustration, terminal covers
are not shown. See page 5)
@ GROUND пет SWITCH (FOR EACH CHANNEL)
Connects or isolates the ground of XLR-pin 1. Usually left
ON. However, in some cases where ground loops are
causing hum, “lifting” the ground by turning this switch
OFF can interrupt the loop, thereby reducing hum.
@ INPUT CONNECTORS (XLR-3-31)
These female input connectors are usually used as inputs.
They are wired: Pin1=ground, Pin2=hot, Pin3=cold.
Compatible connectors include ITT-Cannon XLR-3-12C,
Switchcraft 5C-1055A and Neutric NC3MX.
зле CHANNEL A
(EN I `
МАХ RMS OUTPUT мах, AS OUTPUT í
Ta (53.0V) Ñ
SP WIRING CLASS N 2
2 WIRING MAY ВЕ
USED (STEREO)
Cord Reel
МАНА 22“ елм AMBUNIER
YAMA 0/80xi
YAMAHA | CORPORATION
унео
@ INPUT CONNECTORS (XLR-3-32)
These male inputs duplicate the female input connectors
(same wiring), but are usually used for retransmitting the
input signal to other amplifiers. Compatible connectors
include ITT-Cannon XLR-3-11C, Switchcraft 5C-1056A
and Neutric NC3FX.
© PHONE INPUT CONNECTORS
These 1/4-inch balanced TRS connectors accept balanced
and unblanced input signals. Tip=hot, Ring=cold,
Sleeve=ground.
@ MODE SELECTOR SWITCH (BTL) |
When set to МОМО, this switch allows bridged (mono)
operation of the amplifier. The speaker terminals should
be connected to the “+” terminals of both channels (CH-A
to the speaker "+" and CH-B to the speaker "-"). When
using the PC4002/4002M in BTL (MONO) mode, соп-
nection should be.made to CH-A input only.