Yamaha Programmable Mixer 01 - Pre-Fader or Post-Fader Patches

74 Chapter 8: Dynamics Processors
ProMix 01 User’s Guide
1. Press [UTILITY].
The UTILITY menu appears.
2. Select OUTPUT COMP
PATCH POINT and press
[ENTER].
The OUTPUT COMP PATCH
POINT LCD function appears.
3. Use the cursor buttons to
select parameters and the
[ENTER] button or PARAM-
ETER wheel to set them.
4. To exit this function and
return to the UTILITY menu,
select EXIT and press
[ENTER], or just press [UTIL-
ITY].
The UTILITY menu reappears.
Pre-Fader or Post-Fader Patches
SEND3, SEND4, and stereo output dynamics processor patch points
can be configured pre-fader or post-fader. These settings are made on
the OUTPUT COMP PATCH POINT LCD function, shown below.
Initially, they are all configured post-fader.