Setting the equalizer
Selects the type of equalizer to adjust the tone.
Setup menu
“Speaker” > “Equalizer” > “EQ Select”
Settings
PEQ Applies the parametric equalizer values obtained by the YPAO measurement.
GEQ Adjusts the equalizer manually.
Off Does not use the equalizer.
When selecting “GEQ”
1 Select “Channel” and then select the desired speaker channel.
2 Select the desired band (frequency) and adjust the gain.
Setting range
-6.0 dB to +6.0 dB
3 Press SETUP.
This completes the settings.
NOTE
(
Test tone output helps you to adjust the equalizer while confirming its effect
(
“PEQ” is available only when the YPAO has been performed.
Related links
(
“Outputting test tones”(p.172)
(
“Flow of the speaker configurations”(p.73)
(
“Basic operation of the Setup menu”(p.151)
170
CONFIGURATIONS > Configuring various functions (Setup menu)
To Next Page
