Basics SectionQuick GuideReferenceAppendix
77
Display Messages
Display Messages
Message Meanings
Relevant Sequencer Operations or Standard MIDI File Playback
!Can’tOpen Can’t find the specified type of file.
!Can’tPlay Can’t play the sequencer in these operating conditions.
!IllglFile The specified SMF for playing is unusable by the S08.
!No SMF The SMF was not found on the card.
!Not Frmt0 The SMF format (1) is not supported by the S08 (page 51).
!Not SMF Can’t play the specified type of file (page 51).
!IllglSMF* An error in reading the SMF (other than those described above) occurred.
Relevant Card Operations
!Bad File Data in the file is corrupted and cannot be used.
!Can’tOpen An error occurred while reading from Memory card.
!Card Full No more available memory on the Memory Card.
!FileHdErr File format is not recognized.
File None Can’t find the specified type of file.
!Format An error occurred while formatting the card. Format the card again.
!Mount Err An error occurred while mounting the Memory Card.
!No Card Memory Card has not been inserted, or an incompatible card (5V type) has been inserted.
!No Name Specify the file name.
!OVER 256 No more files can be created.
OverWrite There is a file already stored with the same name. Replace it with a newer one with that name?
!Protected Memory Card is write protected.
!Read Only File is a read-only type, and cannot be deleted, renamed or overwritten.
!SameName File with the same name already exists.
!TooMany The maximum number of displaying files (100) has been exceeded.
!Write Err An error occurred while writing to Memory card.
Others
!BatteryLo The memory-backup battery is low; memory cannot be backed up. Store the necessary data to a Memory Card
or a MIDI data storage device such as Yamaha MIDI Data Filer MDF3, and have the battery changed by your
local Yamaha dealer or any other authorized Yamaha service personnel.
!Buff Full Failed to process the MIDI data because too much data was received at once.
Bulk Rx... MIDI Bulk data being received.
Bulk Tx... MIDI Bulk data being transmitted.
!Checksum Error occurred when receiving bulk data.
Completed! Operation has been completed.
!DeviceNum Bulk data cannot be transmitted/received because the device number does not match or is set to “off.”
Executing Operation is being executed.
!MIDI Data Error occurred when receiving MIDI data.
Sure? Final confirmation.
To Next Page
Loading...
