Yamaha WR450F 2021 - Checking and Lubricating the Cables; Checking the Chassis Fasteners; Checking the Sidestand; Lubricating the Brake Lever

CHASSIS
3-34
EAM30253
CHECKING THE CHASSIS FASTENERS
Make sure that all nuts, bolts, and screws are
properly tightened.
Refer to “CHASSIS TIGHTENING TORQUES”
on page 2-14.
EAM30248
CHECKING AND LUBRICATING THE
CABLES
The following procedure applies to all of the in-
ner and outer cables.
WARNING
EWA13270
Damaged outer cable may cause the cable to
corrode and interfere with its movement. Re-
place damaged outer cable and inner cables
as soon as possible.
1. Check:
• Outer cable
Damage  Replace.
2. Check:
• Cable operation
Rough movement  Lubricate.
TIP
Hold the cable end upright and pour a few drops
of lubricant into the cable sheath or use a suit-
able lubricating device.
EAM30483
LUBRICATING THE BRAKE LEVER
1. Lubricate the pivoting points and metal-to-
metal moving parts of the following parts.
• Brake lever
EAM30503
LUBRICATING THE CLUTCH LEVER
1. Lubricate the pivoting points and metal-to-
metal moving parts of the following parts.
• Clutch lever
EAM30250
LUBRICATING THE PEDAL
1. Lubricate the pivoting point and metal-to-met-
al moving parts of the pedal.
EAM30504
CHECKING THE SIDESTAND
1. Check:
• Sidestand operation
Check that the sidestand moves smoothly.
Rough movement  Repair or replace.
EAM30252
LUBRICATING THE SIDESTAND
Lubricate the pivoting point and metal-to-metal
moving parts of the sidestand.
Recommended lubricant
Engine oil or a suitable cable lu-
bricant
Recommended lubricant
Silicone grease
Recommended lubricant
Lithium-soap-based grease
Recommended lubricant
Lithium-soap-based grease
Recommended lubricant
Lithium-soap-based grease