15
VE2700-8
5. Proper operation
5.6 Adjusting the position of the presser foot
5.5
Pressure of the presser foot
5.4
Adjusting the thread tension
Adjust the thread tension with the thread tension spring
caps ① depending on material type, thread type, seam
width, stitch length, and other sewing conditions.
● To tighten the thread tension, turn the caps clockwise.
● To loosen the thread tension, turn the caps counter-
clockwise.
Loosen the lock nut ② and turn the presser spring regu-
lator ③ to adjust the pressure.
● To increase the pressure, turn it clockwise.
● To decrease the pressure, turn it counterclockwise.
Keep the pressure as low as possible for stable sewing
performance.
Adjust the right-and-left position of the needle holes of
the presser foot.
Loosen the screw ④. Move the front of the presser foot
right or left so that the needles drop in the centers of the
needle holes respectively.
Then, tighten the screw ④ securely.
Fig. 5-7
Fig. 5-8
Fig. 5-9
Needles
Tighten
Loosen
①
②
③
④
Decrease
Increase
Before performing this work, ALWAYS turn the
power switch OFF and check that the motor has
already stopped.
ÃÁÕÔÉÏÎ
To Next Page
Loading...
Need help?
General
