10
The file or the deburring tool could bump the chuck.
34. For the lathe driven by the clutch, take care that the clutch should
be at the position the lathe is stopped when making measurement.
35. Take care of rotating and stopping positions of the spindle when
hand is on the handle of the clutch.
36. Ensure the spindle of the lathe should be at the stop position when
measuring the workpiece jigged on the chuck.
37. When the measuring meter is used on the lathe, ensure the motor is
at the stop status.
38. Wear protective gears met with safe standard before making
operation on the lathe;
It is not allowed if taking off protective gears in a short period of time
before making operation on the lathe;
Wear protective gears properly.
39. Take cars of cuttings flying out from the lathe.
40. Select suitable guard plate on the operation position.
41. Never leap over or go around the chuck or the workpiece to make
adjustment when they are in running status;
Never leap over or go around the chuck or the workpiece to take
something;
Take care of the place the workpiece is put when making adjustment of
the lathe or the workpiece;
Never leap over or go around the chuck or the workpiece to move the
tool/lathe to other position;
Never leap over or go around the chuck or the workpiece to tighten
parts on the lathe;
Never leap over or go around the chuck or the workpiece to remove
iron chips.
42. Master suitable method to load, and never apply force from
unsuitable position.
Instructions Manual for CL-38 (L190)
To Next Page
Loading...