9
by the chuck or the workpiece.
20. Take care not to push the handle, to operate the clutch or to witch
on power supply to cause accident.
21. Master every function and all kinds of operation methods.
22. Never put your hands on the chuck or the workpiece to stop
rotation of the spindle.
23. For the lathe driven by the clutch, in case the clutch is disengaged,
the spindle should be stopped running otherwise the clutch or the brake
device should be adjusted.
24. When the lathe is not in use, ensure to switch off power supply of
the lathe.
25. Stop the rotation of the chuck before replacing the new workpiece.
26. Always take care to check if driving of the chuck, the belt pulley
and driving parts are loose.
27. When the handle of the chuck is in the chuck, never start the
spindle.
28. Do not operate the laths if the attention is not concentrated in order
to avoid accident.
29. When preparing to make other operation of the lathe such as the
tailstock, take care to avoid danger such as bumping or dropping.
30. Take care of guard cover of the chuck and other covers which
cannot be loosened.
31. Put on the safety cap to operate the lathe if the operator has long
hair to avoid danger due to hair is wounded by rotating parts of the
machine.
32. Take special care to make operation if you are closing to rotating
part of the machine.
33. Always pay attention to filing and deburring:
Take special care when the file or the deburring tool is closing to the
chuck;
Instructions Manual for CL-38 (L190)
To Next Page
Loading...