8
4. Grasp the handy tool or the operation grippe on recommended
positions.
5. Do not allow to leave other handy tool or operation gripper on the
chuck.
6. Do not allow to use broken, damaged or defected tool.
7. Ensure the workpiece is jigged firmly on the chuck or other jiggers.
8. Take special care of irregular workpiece.
9. Take care of large flashes and burrs on the workpiece.
10. Always take care to select correct tool in work.
11. It is not allowed to leave other unfixed handy tool or operation
gripper on the chuck.
12. Do not allow to use the tool without the handle.
13. Always adopt the chuck, the follow rest and the center to support
the workpiece.
14. The workpiece should have correct position in the hexagon hole
and the groove of the screwdriver.
15. Take care that the locking screw should be tightened.
16. Do not make preparation work in a hurry.
17. Never use the substitute tool if no suitable tool is available or
prepared in the workshop.
18. Do not allow to move away the guard plate or to open the
protection door when the lathe is switched on.
19. Do not let your hands or body be within the working area of
moving parts.
Take care to move parts of the lathe which could drop down.
Take care of relative position between the hand or the body and the
lathe.
Take care of the tool to be grasped and other parts inserted in the chuck
or the workpiece.
Do not let your hands or body be on the place where they could be hurt
Instructions Manual for CL-38 (L190)
To Next Page
Loading...