4 support@yardistrystructures.com
Instructions for Proper Maintenance
Your Yardistry structure is designed and constructed of quality materials. As with all outdoor products it
will weather and wear. To maximize the enjoyment, safety and life of your structure it is important that
you, the owner, properly maintain it.
Symbols:
Throughout these instructions symbols are provided in the top, right-hand corner of the page.
If you dispose of your Yardistry structure: Please disassemble and dispose of your unit so that it
does not create any unreasonable hazards at the time it is discarded. Be sure to follow your local waste
ordinances.
HARDWARE:
• Check metal parts for rust. If found, sand and repaint using a non-lead paint complying with 16 CFR
1303.
•
annually. Do not over-tighten as to cause crushing and splintering of wood.
• Check for sharp edges or protruding screw threads, add washers if required.
WOOD PARTS:
• Applying a water repellent or stain (water-based) on a yearly basis is important maintenance to
maintain maximum life and performance of the product.
• Check all wood members for deterioration, structural damage and splintering. Sand down splinters
and replace deteriorated wood members. As with all wood, some checking and small cracks in grain
is normal
• Some gapping may occur at some wood connections.
POLY CARBONATE PANELS:
• Clean panels with mild soap and water using a soft cloth or sponge.
• Inspect silicone seal around each panel for separation. Reapply silicone seal as needed.
SINGLE SPRING ALUMINUM WINDOW OPENER:
• At the end of the warm weather season the cylinder must be removed from the greenhouse and
stored in a dry place.
• Lubricate the cylinder before re-installing each time.
• Tape Measure
• Carpenters Level
• Standard or Cordless Drill
• Claw Hammer
Assembly Guides
• Hard Hat
• Safety Glasses
• Adult Helper
• Safety Gloves
Tools Required:
• Use Help, where this is shown, 2, 3 or 4
people are required to safely complete
this step. To avoid injury or damage to the
assembly make sure to get some help.
• Use a measuring tape to assure proper
location
• Pre-drill a pilot hole before fastening
screw or lag to prevent splitting of wood.
• 6’ Step Ladder
• Square
• Caulking Gun
To Next Page
Loading...
Need help?
General