5 support@yardistrystructures.com
PRE-ASSEMBLIES:
•
•
•
POLY CARBONATE PARTS:
• Material may have sharp edges, wear safety gloves.
• Remove all plastic covering, on both sides of the poly carbonate panels,
directly before installing each piece.
• Place poly carbonate parts on a non-abrasive surface before and after
assembly as it can bend, dent and scratch easily.
• When standing on the outside of the unit, the notch in the poly carbonate
panel needs to be on the bottom right-hand side.
•
TAPE:
• Do not substitute tape.
• Tape should be applied in temperatures above 10
°
C (50
°
F).
SINGLE SPRING ALUMINUM WINDOW OPENER:
• Before installing, place black cylinder in the refridgerator for approximately
5-7 minutes or until cylinder rod has fully retracted.
• Automatic ventilation will not occur in temperatures above 50
°
C (122
°
F).
GUIDE SPACERS:
• Included to help align grooves in wood parts to properly install poly carbonate
panels.
WINTER AND HIGH WIND PREPARATION:
• Any accumulated snow must be removed from roof.
Assembly Tips
To Next Page
Loading...