66 support@yardistrystructures.com
F17.1
Remove lm from both sides of Roof Panels and Small
Roof Panels.
A: Refer to pages 16 and 17 and apply top and bottom tape
to Roof Panels and Small Roof Panels.
B: On the Side Wall side, in the grooves of Left and Right
Roof Rafters and Middle Roof Rafters slide four Roof Panels
notch at the bottom is always on the right side of the panel.
Holes are at the bottom of the panels. The UV coated side
must be to the outside of the Assembly. (F17.1)
C: On the Vent Side Wall side, in the grooves of Left and
Right Roof Rafters, Middle Roof Rafters and Vent Roof
Rafter slide two Roof Panels and two Small Roof Rafter
and (1128) Bottom Vent Block. Make sure the notch at the
bottom is always on the right side of the panel. Holes are at
the bottom of the panels. The UV coated side must be to the
outside of the Assembly. (F17.2 and F17.3)
Components
6 x Roof Panel
2 x Small Roof Panel
Top Tape
Bottom Tape
Roof
Panel
Bottom Tape
Note: Notches
always at the
bottom right of
each panel
Notches on
this side
Top Tape
Step 17: Install Roof Panels
Part 1
F17.3
F17.2
Post
(1115) Right
Roof Rafter
(1116) Left
Roof Rafter
(1114)
Middle Roof
Rafter
Side Wall
Vent Side Wall
(1124) Vent
Roof Peak
(1123) Roof
(1114) Middle
Roof Rafter
(1115) Right
Roof Rafter
(1116) Left
Roof Rafter
Note: UV
Coating to the
outside of the
frame
(1127) Vent
Roof Rafter
(1128) Bottom
Vent Block
Roof
Panel
Small Roof
Panel
Roof
Panel
To Next Page
Loading...