4.8 CHECK OF MOTOR PARAMETERS
(1) Check Method of Motor Parameters
When user constant Cn-00 is set to 05, the system enters the motor parameter
check mode.
PanelDisplay n u n
_,,_oo_ ,_o. [!_ U o_
SW2 SWl SW2
_] "'" _'_N _ "'" _'_ MOTOR PARAMETER DISPL.AY
SW3 SWl SW3 l
|
r<...=:_ _ ---+=_v_ [7_, n
SW4 SWI SW4
MODIFICATION DISPLAY
<tm
PAFIAMETER VERSION DISPLAY
_m
Fig. 4.11 SwitchFunctionsin MotorParameterCheck
[] Set up item number 00 with _-}, _-_, _-], or _ key.
[] With the _ key, display the data related to the selected item number.
[] With the _, [-_, _, or [-_ key, select the number 05.
[] With the _ key, check the motor parameter.
[] With the I DATA Ikey, return to the item No. display status.
[] Using the _ key, switch from the setting mode to the monitor mode.
--18--
To Next Page
Loading...
Need help?
General