Index
Index- 5
integral reset, V/f control with PG
,
6-45
integral time
flux vector control, 6-36,6-44
low-speed gain, 6-36,6-44
proportional gain
flux vector control, 6-36,6-44
low-speed gain, 6-36,6-44
responsiveness, flux vector control
,
6-37
V/f control with PG
,
6-44
speed control gain, flux vector control
,
6-38
fine adjustments
,
6-38
speed control integral reset
,
7-67
speed control proportional gain
,
7-75
speed feedback
,
7-5
speed limit function
,
7-22
speed search function
,
7-44
speed torque control change
,
7-74
stall prevention function settings
,
7-87
Status Monitor
,
4-12
stopping method
,
6-12
coasting
,
6-12
coasting with timer
,
6-13
DC injection braking
,
6-12
deceleration,
6-12
flux vector control
,
6-31
surge absorber
,
3-14
SVE (zero servo fault)
,
9-4
switching, speed control and torque control
,
7-27
timer
,
7-28
T
temperature
,
2-6
terminal block
,
3-5
timer function
,
7-45
torque compensation function
,
7 - 25, 7 - 55
torque control
,
1-4,7-21
torque limits
,
7-4,7-30
analog inputs
,
7-4,7-30
torque reference
,
7-21
primary filter
,
7-25
Transmission Option Card DPRAM error (CPF23)
,
9-5
Transmission Option Card model code error (CPF22)
,
9-5
Transmission Option Card self diagnostic error (CPF21)
,
9-5
trim control increase and decrease
,
7-70
troubleshooting
,
9-1,9-9
U
up and down commands
,
7-68
user constants
,
4-23
application constants
,
8-5
autotuning
acceleration/deceleration, 8-11
carrier frequency, 8-15
factory tuning, 8-16
hunting prevention, 8-15
motor slip compensation, 8-12
S-curve acceleration/deceleration, 8-12
speed control, 8-14
torque compensation, 8-13
autotuning constants
,
8-11
constants with factory settings dependent on
control method,
8-45
constants with factory settings dependent on
inverter capacity
,
8-47
DC braking ,
8-6
droop control
,
8-9
dwell functions
,
8-9
factory settings ,
12 - 15
initializing
,
4-21
lists
initialize mode, 8-3
programming mode, 8-5
motor constants
,
8-20
motor 2 control method, 8-22
motor 2 setup, 8-23
motor 2 V/f pattern, 8-22
motor setup, 8-21
V/f pattern, 8-20
operation mode selections
,
8-5
operator constants
,
8-43
monitor selections, 8-43
multi-function selections, 8-44
options
,
8-24
other option setup, 8-26
PG option setup, 8-24
PID control
,
8-8
protection constants,
8-35
fault restart, 8-39
hardware protection, 8-41
motor overload, 8-35
power loss ridethrough, 8-35
reference directions, 8-39
stall prevention, 8-37
torque detection, 8-40
torque limits, 8-40
reference constants
,
8-17
To Next Page
Loading...