4.2 Modes
4-25
Step RemarksDigital Operator DisplayKey Sequence
Access Level
User Program
After a few seconds, the Operator dis-
play is as shown on the left.
16
ESC
G5: Main Menu :
Initialize
The access level has been set to the user program access level.
Figure 4.10 shows the structure of the user constants.
Operation mode
Initialize mode
Programming mode
Language
Password
Function Selection A2
Access Level
Control Method
Initialize
A2-02 User Param 2
A2-32 User Param 32
A2-01 User Param 1
These user constants can be changed and displayed only in
the Advanced access level.
MENU
Fig
4.10 Structure of User Constants
4.2.6 Programming Mode
The Inverter user constants can be set in programming mode. The user constants which can be changed
and displayed depend on the access level and control method that are being used. Refer to the following
table to determine if a user constant can be changed.
The groups of constants in programming mode and their functions are shown in Table 4.5.
4
To Next Page
Loading...