YASKAWA GPD 505/P5 - CALL SI-F;G Comcall

PP.P5G5.03.Troubleshoot
Page 39
Rev. 06/11/2003
Fault Codes
Parameter Setting Error - Inverter can’t run. The fault is displayed
on the digital operator, and the fault relay is not activated.
CALL
SI-F/G ComCall
Serial communication transmission error.
Communication has not yet been established.
N/A
Possible Cause(s): Connection is broken, master has stopped communicating.
Corrective Action: Check all connections, verify all user side software configurations.
505
506 515 √