3 Receiving
8 YASKAWA ELECTRIC SIEP YEUOCL1 01A CANopen-Lift Communication Option Installation Manual
• Read or modify inverter drive for Lift parameters.
The CANopen-Lift Option supports the following communication profiles:
• CiA-301 Ver. 4.02
• CiA-417 Ver. 2.2.0, Profile Velocity and Profile Position
◆ Applicable Models
The option can be used with the drive models in Table 2.1:
Table 2.1 Applicable Models
Option Card Model Drive Series Software Version
SI-L3 L1000A For L1000A 400V class: VSA923400 and higher
For software version, see “PRG” on the nameplate of the drive or regenerative unit.
3 Receiving
This instruction manual contains the information necessary to use the product correctly. Thoroughly read this
manual before installing, wiring, operating, or performing maintenance and inspections. Make sure to read and
understand the safety information and precautions before using the product.
◆ Receiving the Option Card
Please perform the following tasks after receiving the Communication Option card:
• Inspect the Communication Option card for damage. If the Communication Option card appears damaged upon
receipt, contact the shipper immediately.
• Verify receipt of the correct model by checking the information on the PCB.
• If you have received the wrong option card model or the Communication Option card does not function
properly, contact your supplier.
◆ Content and Packaging
Table 3.1 Option Package Contents for SI-L3 (Inverter Drive for Lift L1000A)
Description Option Card Ground Cables Screws (M3) LED Label Installation
Manual
Illustration
Quantity 1 1 3 1 1
◆ Tools Required
A Phillips screwdriver PH1(#1) or PH2(#2) is required to install the Communication Option card.
Note:
Tools required to prepare communication network cables for wiring are not listed in this manual.
To Next Page
Loading...
Need help?
General
