8 YASKAWA ELECTRIC SIEP C730600 70B V1000 Option SI-EP3/V Technical Manual
3 Receiving
3 Receiving
After receiving the option package:
1. Make sure that the option is not damaged and no parts are missing. Contact your sales outlet if the option or other parts
appear damaged.
NOTICE: Do not use damaged parts to connect the drive and the option. Failure to comply could damage the drive and option.
2. Confirm that the model number on the option nameplate and the model listed in the purchase order are the same. Refer
to on page for details. Contact the distributor where the option was purchased or the Yaskawa sales office
immediately about any problems with the option.
Option Package Contents
Table 2 Option Package Contents
Installation Tools
A Phillips screwdriver (M3, M3.5 to M6 metric or #1, #2 U.S. standard
<1>
) is required to install the option.
Description: Option Unit Ground Wire Warning Labels Installation Manual
_
Quantity: 1 411
<1> Screw sizes vary by drive capacity. Select a screwdriver that matches the drive capacity.
MANUAL
PROFINET_E_conditional.fm 8 ページ ２０１６年６月２０日 月曜日 午後８時２分
To Next Page
Loading...
Need help?
General
