YASKAWA SI-EP3

5 Installation Procedure
YASKAWA ELECTRIC SIEP C730600 89C YASKAWA AC Drive Option SI-EP3 Technical Manual 13
 Procedures for Installing and Wiring Options on a Drive
Procedures for installing and wiring options differ depending on the drive model.
Refer to Table 6 to check the procedures for installing and wiring options on a drive.
Table 6 Procedures for Installing and Wiring Options on a Drive
 Procedure A
This section shows the procedure to install and wire the option on a 1000-series drive.
Prepare the Drive for the Option
1. Correctly wire the drive as specified by the manual packaged with the drive.
2. Make sure that the drive functions correctly.
Refer to Figure 3 for an exploded view of the drive with the option and related components for reference in the
installation procedure.
Figure 3
Figure 3 Drive Components with Option
Properly connect all pins and connectors on the option and drive.
Failure to comply could prevent proper operation and damage equipment.
Confirm that all connections are correct after installing the option and connecting peripheral devices.
Failure to comply could damage the option.
Product Series
Procedures for Installing and Wiring
Options on a Drive
Page
A1000 Procedure A 13
U1000 Procedure A 13
U1000L Procedure A 13
Z1000U Procedure A 13
GA700 Procedure B 18
GA800 Procedure B 18
A – Insertion point for CN5 connector K – Option modular connector CN1 port 2
B – SI-EP3 option L – Drive grounding terminal (FE)
C – Drive front cover M – Connector CN5-A
D – Keypad N – Connector CN5-B
(Not available for communication option
installation.)
E – LED label
F – Drive terminal cover
G – Removable tabs for wire routing O – Connector CN5-C
(Not available for communication option
installation.)
H – Included screws
I – Ground wire
J – Option modular connector CN1 port 1
NOTICE
F
H
M
N
O
L
K
I
B
C
D
E
A
G
J
NS MS
A1000