YASKAWA U1000 iQpump Drive - AUTO Mode Operation (Continued); Place Drive into AUTO Mode; Set System Setpoint for AUTO Mode

YASKAWA TOEPYAIUPW02A U1000 iQpump Drive Quick Start Procedure
U1000 iQpump Drive
Quick Start Procedure
Page 18
of 25

AUTO Mode Operation (continued)
10
STEP
10.1 Place the Drive into AUTO Mode.
Press the AUTO key to place the drive into AUTO mode.
Auto Mode Activation
LED is blinking when
A
UTO mode is active and
A
UTO RUN COMMAND is
not active.
Press to turn OFF
Press AUTO key
Setpoint
U1-02= 00.00Hz
U5-99= 0.0 PSI
- MODE - DRV Rdy
U1-91= 56.2PSI
MONITOR
LSEQ
LREF
Auto Setpoint
10.2 Set System Setpoint
Press
to access or modify the system setpoint in parameter Q1-01 within the Quick Setup Menu.
Press
to select the digit andto change the system setpoint.
Press to store setpoint and pressto return to the main operation menu.
F1
The drive is capable of starting or stopping based on the Run Command Selection setting in parameter b1-02.
(Refer to Step 4.6 for an example of setting a parameter.)
The setpoint used in AUTO mode is based on the Frequency Reference Selection setting in parameter b1-01.
(Refer to Step 4.6 for an example of setting a parameter.)