WARNING! Crush Hazard.
Observe the following instructions and precautions. Failure to comply could result in serious injury or death from
falling equipment.
Only use vertical suspension to temporarily lift the drive during installation to an enclosure panel. Do not use vertical suspension to transport
the drive.
Confirm that the spring washer is completely closed prior to lifting to prevent damage to the drive.
Use screws to securely affix the drive front cover, terminal blocks, and other drive components prior to vertical suspension.
Do not subject the drive to vibration or impact greater than 1.96 m/s
2
(0.2 G) while it is suspended by the wires.
Do not leave the drive unattended while it is suspended by the wires.
Do not attempt to flip the drive over while it is suspended by the wires.
A – No space between drive and
washer
B – Spring washer fully closed
C – Space between drive and washer
D – Spring washer open
Figure i.10 Spring Washer
n
Horizontal Suspension
of Drive Models 2o0154 to 2o0248, 4o0156 to 4o0930, and Harmonic
Filter Module
To make a wire hanger or frame for use when lifting the drive with a crane, lay the drive in a horizontal position and pass a
wire through the hanging brackets.
NOTICE: Use the hanging brackets on the top and hanging holes of the bottom cover when lifting drive models 2
o
0154F, 2
o
0192F,
4
o
0156F, and 4
o
0180F.
2□0154F, 2□0192F, 4 □0156F, and 4□0180F
4□0720A to 4□0930A,
and Harmonic Filter Module
2□0154A, 2□0192A, 2□0248,
4□0156A, 4□0180A, and 4□0216 to 4□0590,
Figure i.11 Horizontal Suspension of Drive Model 2o0154
n
Vertical Suspension of the Drive and Harmonic Filter Module
Follow
the
procedure described below when suspending the drive or harmonic filter module with eye bolts or hanging brackets.
Drive Models 2
o
0028 to 2
o
0130 and 4
o
0011 to 4
o
0124
i.3 Mechanical Installation
YASKAWA ELECTRIC TOEP C710636 04D U1000 Industrial MATRIX Drive Quick Start Guide
21
To Next Page
Loading...
