■ Model JANCD-FC400
Swl :
System number switch (16-position rotary switch)
Swl[o]:
[11:
[2]:
[41:
*
e-
Normal operation mode
When power is applied, the system is
started up in synchronization with NC
and an application program (index
‘1
1
II
)
is executed immediately.
NC built-in program development mode
When power is applied, the system is
started up in synchronization with NC
and the screen of application program
development mode is displayed.
Stand-alone execution mode
When power is applied,
ACGC
is
started up singly and an application
program (index
“
1“
) is executed
immediately.
Stand-alone program development mode
When power is applied, ACGC is
started up singly and the screen of
application program development mode
is displayed.
SW [3], and [5] to [F] are
used only for maintenance.
Only YASKAWA service personnel
must use these switches.
199
To Next Page
Loading...