Yealink SIP-T33P Administrator's Guide

Administrator’s Guide for SIP-T2 /T3 /T4 /T5 /CP920 IP Phones
126
Permitted
Values
-1-Do not modify the handset configuration (Keep the original configuration of the handset).
0-Disabled, the backlight will be turned off after the handset is idle for about 10 seconds.
1-Enabled, the backlight will be turned off after the handset is idle for about 30 minutes.
Default
-1
Supported
Devices
W53H, W56H
Handset UI
OK > Settings > Display > Display Backlight > In Charger
Parameter
custom.handset.backlight_out_of_charger.enable <y0000000000xx>.cfg
Description
It enables or disables the handset backlight to be on for about 30 minutes when it is not charged.
Note: It will take effect on all handsets that are registered on the same phone. It works only if “stat-
ic.auto_provision.handset_configured.enable” is set to 1 (Enabled).
Permitted
Values
-1-Do not modify the handset configuration (Keep the original configuration of the handset).
0-Disabled, the backlight will be turned off after the handset is idle for about 10 seconds.
1-Enabled, the backlight will be turned off after the handset is idle for about 30 minutes.
Default
-1
Supported
Devices
W53H, W56H
Handset UI
OK > Settings > Display > Display Backlight > Out Of Charger
Handset Keypad Light
You can enable the handset keypad light to light up the keypad when any key is pressed. This helps you dis-
tinguish keys from each other in a dark environment.
Topic
Handset Keypad Light Configuration
Handset Keypad Light Configuration
The following table lists the parameter you can use to configure the handset keypad light.
Parameter
custom.handset.keypad_light.enable <y0000000000xx>.cfg
Description
It enables or disables the handset to turn on the keypad light (digital key, # key, * key, TRAN key, and
Mute key) when any key is pressed.
Note: It will take effect on all handsets that are registered to the same phone. It works only if “stat-
ic.auto_provision.handset_configured.enable” is set to 1 (Enabled).
Permitted
Values
-1-Do not modify the configuration.
0-Disabled
1-Enabled
Default
-1
Supported
Devices
W53H, W56H
Handset UI
OK > Settings > Display > Keypad LED

Yealink SIP-T33P Specifications

General

Mounting	Desk/Wall
Handset type	Wired handset
Product type	IP Phone
Product color	Gray
Wall mountable	Yes
Operating system installed	Linux
Lines quantity	4 lines
Phonebook capacity	1000 entries
Number of VoIP accounts	4
Volume control	Buttons
Number of function keys	5
Display diagonal	2.4 \
Display resolution	320 x 240 pixels
Voice codecs	AGC, AJB, CNG, G.711a, G.711u, G.722, G.723.1, G.726, G.729, G.729A, PLC, VAD, iLBC
Security algorithms	AES, HTTPS
Ethernet LAN data rates	10, 100 Mbit/s
Ethernet LAN interface type	Fast Ethernet
RJ-9 ports quantity	1
Ethernet LAN (RJ-45) ports	2
Input frequency	50/60 Hz
AC adapter input voltage	100 - 240 V
Power consumption (typical)	3 W
Power consumption (Power over Ethernet (PoE))	5 W
Number of handles included	1 pc(s)
Operating temperature (T-T)	-10 - 50 °C
Operating relative humidity (H-H)	10 - 95 %

Weight and Dimensions

Depth	186 mm
Width	212 mm
Height	146 mm