Yealink SIP-T33P Administrator's Guide

Getting Started
20
Getting Started
This chapter describes where Yealink devices fit in your network and provides basic initialization instructions of
devices.
Topics
Requirements
Yealink IP Phones in a Network
Initialization Process Overview
Verifying Startup
Requirements
In order to perform as SIP endpoints in your network successfully, you need the following in deployments:
l A working IP network is established.
l VoIP gateways configured for SIP.
l The latest (or compatible) firmware of the device is available.
l A call server is active and configured to receive and send SIP messages.
l A text editor, such as Notepad++, to create and edit boot files, configuration files, and resource files.
Yealink IP Phones in a Network
Most Yealink phones are connected physically through a Category 5E (CAT5E) cable to a 10/100/1000Mbps Eth-
ernet LAN, and send and receive all data using the same packet-based technology. Some phones support the wire-
less network.
Since the IP phone is a data terminal, digitized audio being just another type of data from its perspective, the phone
is capable of vastly more than traditional business phones. Moreover, Yealink phones run the same protocols as
your office personal computer, which means that you can develop many innovative applications without resorting to
specialized technology.
There are many ways to set up a phone network using Yealink phones. The following shows an example of a net-
work setup:

Yealink SIP-T33P Specifications

General

Mounting	Desk/Wall
Handset type	Wired handset
Product type	IP Phone
Product color	Gray
Wall mountable	Yes
Operating system installed	Linux
Lines quantity	4 lines
Phonebook capacity	1000 entries
Number of VoIP accounts	4
Volume control	Buttons
Number of function keys	5
Display diagonal	2.4 \
Display resolution	320 x 240 pixels
Voice codecs	AGC, AJB, CNG, G.711a, G.711u, G.722, G.723.1, G.726, G.729, G.729A, PLC, VAD, iLBC
Security algorithms	AES, HTTPS
Ethernet LAN data rates	10, 100 Mbit/s
Ethernet LAN interface type	Fast Ethernet
RJ-9 ports quantity	1
Ethernet LAN (RJ-45) ports	2
Input frequency	50/60 Hz
AC adapter input voltage	100 - 240 V
Power consumption (typical)	3 W
Power consumption (Power over Ethernet (PoE))	5 W
Number of handles included	1 pc(s)
Operating temperature (T-T)	-10 - 50 °C
Operating relative humidity (H-H)	10 - 95 %

Weight and Dimensions

Depth	186 mm
Width	212 mm
Height	146 mm