Yealink W52P - Page 14

14
To place a new call during an active call via the handset:
1. Press Ext.Call. This places the active call on hold.
2. Enter the desired number in the Call To field using the keypad.
3. Press the Call button, the speakerphone button or OK to dial out.
You can place at most two calls at one time on your handset.
To redial the last dialed number:
Press the Call button twice when the handset is idle. It will dial the last dialed
number.
To redial a previously dialed number:
1. Press the Call button when the handset is idle.
2. Select a dialed number using the up or down navigation buttons.
• You can select Options >> Edit Before Call to edit the phone number.
3. Press the Call button again.
To answer a call:
You can answer a call in three ways:
• Using the handset
• Press the Call button or Accept.
• Using the speakerphone
• Press the speakerphone button.
• Using the headset
• With a headset connected, press Accept.
To ignore an incoming call:
Press Silence or hit the End Call key.
To answer a call while on another call:
Press the Call button, the speakerphone button, OK or Accept. This places the
original call on hold and answers the incoming call.
To end a call:
Either press the End Call button or place the handset in the charger cradle.