6
Handset and Charger Cradle
Insert AAA batteries into the handset. For more information about suggested
batteries, read the Yealink user manual online.
To set up the charger cradle and charge the handset:
1. Connect the DC plug on the power adapter to the DC5V port on the
charger cradle.
2. Connect the other end of the power adapter into an electrical power outlet.
3. Place the handset in the charger cradle.
The handset batteries take six (6) hours to fully charge. The charging status of
the batteries is displayed on the top right hand corner of the LCD screen on the
handset.
After charging, the handset is ready for use. When the batteries are low, and
the handset is not charged in a timely manner, the handset will play a warning
tone and display a prompt box every hour.
To restart the handset:
1. Press OK to enter the main menu.
2. Select Settings >> System Settings >> Handset Reset.
3. The handset will ask, “Reset handset to default?” Press Yes to reset the
handset or No to cancel.
To Next Page
Loading...
