Yealink W52P - Product Information and Warnings; DECT Product Information; WEEE Warning; Customer Feedback Request

5
Item Description
4 Power Indicator LED
Indicates the power status
of the base station:
• Slow flashes green when the
base station is during the
firmware upgrading process
• Slow flashes green when the base
station is during the resetting process
• Illuminates solid green when the
base station is powered on
To restart the base station via the handset:
1. Press OK to enter the main menu.
2. Select Settings >> System Settings >> Base Restart.
3. Enter the system PIN (default: 0000).
4. Press Done.
The registration LED and network status LED will go out simultaneously. After a
period of time, the LED indicators will illuminate solid green again when the base
station restarts successfully.
To reset the base station via the handset:
1. Press OK to enter the main menu.
2. Select Settings >> System Settings >> Base Reset.
3. Enter the system PIN (default: 0000).
4. Press Done.
All individual settings for the base station will be reset to factory defaults.
This may take a few minutes. Do not power o until the base station starts up
successfully.