EasyManuals Logo

Yealink W73P User Manual

Yealink W73P
18 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
Page 10 of 18
Yealink W73P | User Guide
© Gamma. All rights reserved. Confidential
Register the Handset(s) to Base Station
You need to register your handset to a base station if you want to use the basic functions of the DECT
phone. You can register up to 10 handsets per base station.
Putting the Base Station into Registration Mode
Before registering the handset, you must put the base station into registration mode. To
do this, long press the registration button (pictured right) on the base station until the
registration LED flashes.
If the base station does not identify a DECT handset within 90 seconds the registration mode will
switch off.
Registering a W73H handset to the Base Station
Once the base station is in registration mode, you can register your handset to the base station. To
do this, press the Reg soft key to register the handset.
The handset is now searching for a base station in registration mode.
After the handset is registered successfully, the phone prompts “Handset Subscribedand “Base
number [The last 4 characters of the connected Base’s MAC address]”.
After the handset initialised successfully, an icon with the internal handset number and handset name
appears on the phone screen.
Registering a W73H to another Base Station
If you wish to change which base station the W73H is registered, then complete the following steps.
Make sure the base station is in the registration mode then:
1. Go to OK > Settings > Registration > Register Handset.
2. Select the desired base and then press OK. The handset begins searching for the base station
which is in registration mode.
3. Press OK after a base is found
4. Enter the base PIN (default is 0000) and then press Done to complete the registration.
After the handset is registered successfully, the phone prompts “Handset Subscribedand Base
number [The last 4 characters of the connected Base’s MAC address]”.
After the handset initialized successfully, an icon with the internal handset number and handset name
appears on the phone screen.

Other manuals for Yealink W73P

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yealink W73P and is the answer not in the manual?

Yealink W73P Specifications

General IconGeneral
Handset typeWireless handset
Product typeIP mobile phone
Product colorGray
Keypad illuminationYes
Caller ID-
Lines quantity- lines
Phonebook capacity100 entries
Battery voltage3.7 V
Battery capacity1010 mAh
Input current0.2 A
Input frequency50/60 Hz
AC adapter input voltage100 - 240 V
AC adapter output current0.6 A
AC adapter output voltage5 V
Storage temperature (T-T)-30 - 70 °C
Operating temperature (T-T)-10 - 50 °C
Operating relative humidity (H-H)10 - 95 %
Display diagonal1.8 \
Display resolution128 x 160 pixels
Number of handles included- pc(s)
Harmonized System (HS) code85171800
Weight and Dimensions IconWeight and Dimensions
Package depth104 mm
Package width181 mm
Handset weight112 g
Package height90 mm
Package weight8314 g
Handset dimensions (WxDxH)144 x 48 x 21 mm

Related product manuals