25
Chapter 6:
Maintenance
Overview:
Basic operator maintenance is covered in this chapter. For more extensive maintenance and for
repair, contact Ritchie Customer Service. See Chapter 1 for contact information.
General Maintenance:
Since this instrument may be used in the presence of a wide range of chemical liquids and vapors,
it is recommended that the case be cleaned often with a damp cloth and mild detergent such as
dish soap.
Although the resistive display is tough and suitable for typical industrial use, take care when
cleaning the display as clarity is a critical component of this instrument:
● Normally, the display can be cleaned as one would clean plastic eyeglass lenses: Use a
soft, 100% cotton or microfiber cloth and water or eyeglass lens cleaning solution. Do not use
paper products.
● If the display is very dirty, generously soak a soft cloth with warm, soapy (dish soap) water
and place the cloth for a couple of minutes over the display to loosen any stubborn dirt. Wipe off
excess water with a clean, less dampened, 100% cotton or microfiber cloth, and complete the
cleaning using the normal display cleaning method described above.
● DO NOT place the device under running water, always use a dampened cloth to transport
liquid to and from the device.
Replacement Parts/Optional Accessories: See Table 6-1 for replacement part numbers.
Table 6-1: Replacement Parts
Micro-USB Cable for P51-TITAN®
(3) 60” RYB Standard Fittings; (1) 60” Y 3/8” str x 3/8”
45° Quick Coupler
60” Yellow 3/8” Straight x 3/8” 45° PLUS II™ “B”
60” 3-PAK RYB Standard Fitting PLUS II™ 1/4” Hose
60” 3-PAK RYB Compact Ball Valve PLUS II™ 1/4” Hose
60” Blue, Compact Ball Valve (1/4” x 5/16”)
60” Red, Compact Ball Valve (1/4” x 5/16”)
To Next Page
Loading...
