IMPORTANT!
READ BEFORE PROCEEDING!
GENERAL SAFETY GUIDELINES
This equipment is a relatively complicated apparatus. During rigging, installation, operation,
maintenance, or service, individuals may be exposed to certain components or conditions including, but
not limited to: heavy objects, refrigerants, materials under pressure, rotating components, and both high
and low voltage. Each of these items has the potential, if misused or handled improperly, to cause bodily
injury or death. It is the obligation and responsibility of rigging, installation, and operating/service
personnel to identify and recognize these inherent hazards, protect themselves, and proceed safely in
completing their tasks. Failure to comply with any of these requirements could result in serious damage
to the equipment and the property in which it is situated, as well as severe personal injury or death to
themselves and people at the site.
This document is intended for use by owner-authorized rigging, installation, and operating/service
personnel. It is expected that these individuals possess independent training that will enable them to
perform their assigned tasks properly and safely. It is essential that, prior to performing any task on this
equipment, this individual shall have read and understood the on-product labels, this document and
any referenced materials. This individual shall also be familiar with and comply with all applicable
industry and governmental standards and regulations pertaining to the task in question.
SAFETY SYMBOLS
The following symbols are used in this document to alert the reader to specific situations:
Indicates a possible hazardous situation which will result in death or serious injury if
proper care is not taken.
Identifies a hazard which could lead to damage to the machine, damage to other
equipment and/or environmental pollution if proper care is not taken or instructions
and are not followed.
Cooke Industries - Phone: +64 9 579 2185 Email: sales@cookeindustries.co.nz Web: www.cookeindustries.co.nz
To Next Page
Loading...
