JOHNSON CONTROLS
84
FORM 150.72-ICOM7
ISSUE DATE: 10/22/2020
SECTION 5 – TECHNICAL DATA
DIMENSIONS – YLAA0442HE
SEVEN FAN UNITS
NOTE:
Placement on a level surface of free of obstructions (including snow, for winter operation) or air circulation ensures rated performance, reliable
operation, and ease of maintenance. Site restrictions may compromise minimum clearances indicated below, resulting in unpredictable airow
patterns and possible diminished performance. Johnson Controls’s unit controls will optimize operation without nuisance high-pressure safety
cutouts; however, the system designer must consider potential performance degradation. Access to the unit control center assumes the unit
is no higher than on spring isolators. Recommended minimum clearances: Side to wall – 2 m (6 ft); rear to wall – 2 m (6 ft); control panel
to end wall – 1.2 m (4 ft); top – no obstructions allowed; distance between adjacent units – 10 ft. No more than one adjacent wall may be
higher than the unit.
035-24059-008 REV-D
LD26947
CONTROL PANEL BOTTOM DETAIL
(1298mm EUROPEAN BUILD)
1177 [46.4]
(28mm EUROPEAN BUILD)
21 [0.8]
POWER ENTRY
330.2 [13.00] WIDE X 177.8 [7.00] HIGH
(190mm x 120mm EUROPEAN BUILD)
1669 [65.7]
1132 [44.6]
573 [22.5]
2796 [110.1]
1679 [66.1]
562 [22.1]
2077.265 [81.7821]
82 [3.2]
822 [32.4]
254 [10.0]
36 [1.4]
138 [5.4]
36 [1.4]
MOUNTING
HOLES TYP
MOUNTING
HOLES TYP
MOUNTING
HOLES TYP
16 [5/8”]
1918 [75.5]
1519 [59.8]
3545 [151.4]
4731 [186.3]
4769 [187.8]
FRAME LENGTH
1473 [58.0]
588 [23.2]
1256 [49.5]
1753 [69.0]
195 [7.7]
686 [27.0]
1276 [50.2]
51 [2.0]
(OPTIONAL HEAT
RECOVERY UNIT)
3” VICTAULIC INLET
3” VICTAULIC OUTLET
OPTIONAL
DISCONNECT SWITCH
(STANDARD ON CE)
FRAME WIDTH
OVERALL WIDTH
2242 [88.3]
2256 [88.8]
148 [5.8] OR 288.0 [11.34]
DIMENSION VARIES BASED
ON CHILLER SELECTED
OVERALL HEIGHT DEPENDS ON BUILD LACTATION
REFER TO NOTES 5 AND 6 ABOVE
FRAME HEIGHT
2248 [88.5]
1595 [62.8] (60Hz)
(1497mm (50Hz))
4” VICTAULIC
OUTLET
4” VICTAULIC
INLET
To Next Page
Loading...