37
Zaxis Inc. LLC
801.264.1000
2442 South 2570 West
West Valley City, UT 84119
Ethernet Settings
The following directions are for Windows based operating systems:
1. On your computer: nd the IP address of the computer by running the
command prompt found in START → Accessories. Or type command in the
start menu’s search bar.
2. On the command line: type ipcong, this will display all the data associat-
ed with the Ethernet connections.
3. Scroll down to the section Ethernet adapter Local Area Connection and
record the value of the IPv4-Address.
4. On the Isaac PD: under OPTIONS → ETHERNET SETTINGS, turn the
DHCP selection to OFF.
5. The IP address of the Isaac should be set to one address higher than the
IP address of the laptop.
» Example: If the laptop is: 169.254.96.1, set the Isaac to
169.254.96.2.
6. Verify that the correct sections have been made in the Data Logging
menu for the type of data you wish to collect (Results, 0.1sec, etc.).
7. Verify that Output Results in the PROG menu have the Ethernet box se-
lected for every test you wish to collect.
To Next Page
Loading...
