21
<Hold to push A switch> <Hold to push C switch>
(MIX change)
･The gray square shows a blinking part.
(1)Description of Functions
The dive mode has some modes. There are non-decompression dive mode, decompression dive mode,
safety stop condition, gauge dive mode, out of measurement range condition. The functions of each
dive mode are described below.
<Non-decompression mode>
It is the dive in which the NDL is remained.
<Gage mode>
The only functions that can be performed in this mode are the depth calculation, water temperature
measurement, and dive time measurement functions. Calculation functions, such as PGT and OLI etc,
are not performed. If you use this mode when diving, it is the GAGE mode until 48 hours have elapsed.
When diving by the gage mode, the safe stop isn't function.
<Decompression mode>
This mode is used for dives that last longer than the NDL. Until the advised depth is reached, warning
will continue. If you go to the surface, then after 10 minutes of a surface time, the display will freeze
and all calculation functions will stop. The mode will be automatically switched to time mode after 48
hours have elapsed. This information is recorded in the dive log. After calculations have stopped, you
can switch only to log mode, profile mode, PC transfer mode.
<Push A, B, C switch>
EL back light is on from 4-5 seconds.
<Safety Stop condition>
This shows recommended safety stop time in dive mode. If user dives descent over 9.9m,then user
Water temperature
Maximum
depth
Dive time
Fraction of oxygen
MIX Icon blink
To Next Page
Loading...
