27
<Out of measurement range condition>
All display segments blink.
• A: Press this switch to move to Mix change from 3-4 seconds. And EL back light is on from 4-5
seconds.
• B: EL back light is on from 4-5 seconds.
• C:When user pushes and holds a switch C, it displays the temperature, the dive time, the maximum
water depth and setting FO
2
value. And EL back light is on from 4-5 seconds.
• Less than 1.5 m water detection switch OFF: moves to lock condition.
<Out of measurement range lock>
This mode is locked until 48 hours have elapsed. All display segments blink in time mode.
It can’t move to dive plan mode, dive set mode ,time set mode.
• A: Press this switch to select place you want to change. In time mode, display, EL back light is on from
4-5 seconds.
• B: This switch is mode select switch.
Time mode→Dive log mode→Dive profile mode→PC transfer mode
→Time mode →……
• C: Press this switch to change setting the contents. In time mode, EL back light is on from 4-5 seconds.
• Water detection switch: no function.
<Gage dive mode>
• A: EL back light is on from 4-5 seconds.
• B: EL back light is on from 4-5 seconds.
• C:When user pushes and holds a switch C, it displays the temperature, the dive time, the maximum
water depth. And EL back light is on from 4-5 seconds.
• Hold switch C:When user pushes and holds a switch C, it displays the temperature, the dive time, the
maximum water depth.
• Less than 1.5 m water detection swtich OFF: moves to time mode.
1-3-9.Gage Mode
The only functions that can be performed in this mode are the depth calculation, water temperature
measurement, and dive time measurement functions. Calculation functions (such as calculation of PGT,
OLI etc.) are not performed. If you dive in this mode for 3 minutes or longer, this information will be
recorded in the dive log and profile mode.
To Next Page
Loading...