35
Status Cause, prevention, response
Display is very dim. ・The display dims at low temperature. It will
recover when the temperature returns to normal.
・The battery could be wearing down. Have the
manufacturer change the battery.
Computer will not go into
Dive mode.
・This occurs when there has been a
Decompression Stop Direction Violation Warning
or Out-of-Range Warning. It will recover after
48hours.
・This occurs when the battery is near the end of its
life and the battery mark is blinking or
illuminated. Have the battery changed.
・This occurs when the altitude rank is over 6000m
and the altitude mark blinking. It will recover
when you return to a lower altitude.
・In other cases, this may indicate damage. Return
to manufacturer for repair.
The computer does not return
to surface mode after diving.
・The water sensor switch is still wet. Wipe with a
dry, soft cloth.
Although you are not diving,
the computer goes into time
mode and desaturation time is
displayed.
・This is caused by a change in altitude rank. When
there has been a change in air pressure, the
computer automatically calculates residual
nitrogen. You should use this information in your
diving plan.
Operaing switches do not
make the computer change
mode.
・This occurs when the water sensor switch is wet
after finishing a dive. Wipe the unit well and try
input again.
・In other situations, this may indicate damage.
Bring the unit to the manufacturer for repair.
The no-decompression limit
in the dive plan shows only a
bar.
・This occurs when altitude rank is over 6000m
and the altitude mark blinking. It will recover
when the unit returns to a lower altitude.
・This occurs when FO
2
of MIX1 is left ta default.
・And this occurs when the depth rank is over the
maximum PO
2
depth in dive set mode.
To Next Page
Loading...
