7
<Battery indicator>
Battery indicator Icon: This displays the current battery voltage, as follows.
When battery voltage is 2.8V or above, battery Icon is OFF.
When battery voltage is 2.6 to 2.7 V, battery Icon blinks.
When battery voltage is less than 2.6 V, battery Icon is ON.
You cannot go to dive mode while the battery indicator Icon is blinking or ON. This Icon can be
displayed during all modes except dive mode.
Measurement of battery voltage is automatically performed during all modes except PC transfer mode
and dive mode.
<Altitude rank>
Altitude rank：The computer automatically measures and calculates the current location's altitude and
displays the corresponding altitude rank. The relation between altitude rank levels and altitudes are
shown below. A new altitude measurement and calculation is made once every ten minutes.
When the altitude is over 6000 meters
(19680 feet), the Icons of altitude rank and
‘Err’ blink and the dive computer cannot be used until the altitude drops to a lower level(under 6000
meters (19680 feet)). The calculations of PGT, OLI and desaturation time are stopped when altitude is
over 6000 meters (19680 feet), and ‘Err’ is displayed. But surfase time is continued to be counted. When
the altitude is less than 6000 meters (19680 feet), the display shown before reaching that altitude is
displayed again once the altitude drops to a lower level. The same displays and processing occur if the
altitude cannot be measured for any reason.
Altitude measurements are made during all modes except dive mode and PC transfer mode. Display of
the current altitude rank Icon occurs in Time Mode and Plan Mode (In dive log mode, a rank at a dive is
displayed.)
Altitude
rank
Altitude range
0 0-900m(0-2952ft)
1 600-1800m(1968-5904ft)
2 1500-2600m(4920-8528ft)
3 2300-6000m(7544-19680ft)
Err Over 6000m(over 19680ft)
To Next Page
Loading...
