Configuration
Standard Control Panel Parameters
94
P1009874-001 Xi4 User Guide 3/12/09
Select Print Method
The print method parameter tells the printer the method of printing that you
want to use: direct thermal (no ribbon) or thermal transfer (using thermal
transfer media and ribbon).
Default Value: THERMAL-TRANS.
Selections: THERMAL-TRANS., DIRECT THERMAL
To change the value shown:
1. Press PLUS (+) or MINUS (-) to scroll through the options.
Set Print Width
This parameter specifies the printable area across the width of the label.
Table 10 shows the ranges and default values for print width, which are
based on the printer model and the printhead resolution.
Note • Setting the width too narrow can result in portions of a label
format not being printed on the media. Setting the width too wide
wastes formatting memory and can cause printing off of the label
and on the platen roller. This setting can affect the horizontal
position of the label format if the image was inverted using the
^POI ZPL II command.
To change the value shown:
1. Press PLUS (+) or MINUS (-) to change the value shown.
Table 9 • Printer Parameters (Sheet 4 of 22)
Language/Parameter
Action/Explanation
Table 10 • Print Width Ranges and Maximum Values
Printhead
Resolution
Printer
110Xi4 140Xi4, 170Xi4, 220Xi4
200 dpi
Default Value: 832
Range: 2 to 832 dots
Default Value: 1344
Range: 2 to 1344 dots
300 dpi
Default Value: 1248
Range: 2 to 1248 dots
Default Value: 1984
Range: 2 to 1984 dots
600 dpi
Default Value: 2496
Range: 2 to 2496 dots
N/A
To Next Page
Loading...
Need help?
General
Weight and Dimensions
