18 CS4070 Scanner
Configuring the CS4070
123Scan2
Use the 123Scan2 utility to generate a 2D bar
code with the desired configuration options.
Scan the bar code to configure the scanner with
these options.
Config.ini
Use a text editor such as Notepad to set
configuration values in the Config.ini editable
text file in the \Parameters folder on the
CS4070.
Updating Scanner Firmware
1. Connect the micro USB cable from the host
to the CS4070.
2. Copy the .dat and .bin files to the root
directory of the scanner.
3. Disconnect the cable when the host
indicates that it is safe to remove.
After several minutes the LED turns green to
indicate that the firmware was successfully
installed.
To Next Page
Loading...