5 - 8 ET5X User Guide
Installing the Insert
Install the tall insert when using an ET5X without a Rugged Frame or Expansion Back. Install the small insert when using an
ET5X with an Expansion Back and without a Rugged Frame.
1.
Align the insert over the pins.
Figure 5-8 Align Insert with Cradle
2. Press the insert down until it seats flush in the cradle.
Charging the ET5X
To charge the ET5X in the Communication and Charging Cradle:
1. Open the bottom access door and hold it to the back of the tablet.
2. Align the ET5X with the alignment pins on the cradle.
3. Insert the ET5X into the cradle. Note that the Communication and Charging Cradles contains a locking
mechanism that locks the ET5X to the cradle.
To Next Page
Loading...
