Loading Roll Media
14
P1030829-001 GK888t™ User Guide 12/23/2010
4. Pull the media so that it extends out of the front of the printer. Verify the roll turns freely.
The roll must not sit in the bottom of the media compartment. Verify that the media’s
printing surface is facing up.
5. Push the media under both of the media guides. Close the media guides by turning the
media
guide adjustment knob to the front. The guides should just touch, but not restrict,
the edges of the media.
6. Unless you need to load transfer ribbon, close the top cover. Remember that you need to
release the cover lock, lower the top cover, and press down until the
latches snap into
place.
7. If printer power is on, press the Feed Button to feed media. Otherwise, wait to turn on the
printer and complete the printer ‘Getting Started’ instructions in this chapter.
To Next Page
Loading...