Zebra GK888t User Manual

27
Connecting your Printer to a Computer
12/23/2010 GK888t™ User Guide P1030829-001
Ethernet
The printer requires UTP RJ45 Ethernet cable rated CAT-5 or better.
For more information on configuring your printer to run on a compatible Ethernet based
network, see the ZebraNet® 10/100 Internal Print Server manual. The printer must be
configured to run on your LAN (local area network) or WAN (wide area network). The print
server on board your printer can be accessed through the printer’s Web pages.
Ethernet Status/Activity Indicators
Ethernet Cable
(RJ45 Connector)
LED Status Description
Both OFF No Ethernet link detected
Green 100 Mbps link detected
Green with the Amber
flickering on and off
100 Mbps link and Ethernet activity detected
Amber 10 Mbps link detected
Amber with the Green
flickering on and off
10 Mbps link and Ethernet activity detected
Green LED Amber LED

Zebra GK888t Specifications

General

Print Method	Thermal Transfer and Direct Thermal
Resolution	203 dpi (8 dots/mm)
Maximum Print Width	4.09 inches (104 mm)
Memory	8 MB Flash
Connectivity	USB, Serial, Parallel
Media Sensors	Reflective and transmissive
Media Handling	Roll-to-roll, fanfold, tag stock
Media Types	tag stock
Ribbon Ratio	1:1
Programming Languages	EPL2, ZPL
Power Requirements	2.5A
Storage Temperature	-40° F to 140° F/-40° C to 60° C
Humidity	20 to 85% non-condensing