Zebra ZM400 User Manual

111
Index
2/26/10 ZM400 User Guide for UPS P1016807-001 Rev. A
Liner Take-Up mode
description, 34
loading media, 36
media path, 35
remove used liner, 43
list settings
all settings, 61
bar codes, 60
fonts, 60
formats, 61
images, 60
network, 61
setup, 61
load factory defaults, 49
loading media, 36
lubrication, 76
M
manual calibration, 44
mark LED setting, 70
Mark Med S. setting, 70
maximum label length setting, 57
media
black mark, 31
continuous roll media, 32
fanfold, 32
loading, 36
media LED setting, 70
non-continuous roll media, 31
ordering, 11
perforated, 31
setting media type, 56
specifications, 108
tag stock, 31
types of media, 31
web, 31
media compartment
cleaning, 81
components, 17
media door, 16
media power up setting, 68
Media S. setting, 70
media sensor
calibration, 63
print sensor profile, 62
N
network configuration label
printing, 52
printing using List Network command, 61
network ID setting, 65
non-continuous media
described, 31
setting media type, 56
O
odometer, 60
operating conditions, 24
ordering media, 11
ordering replacement parts, 76
OUT OF MEMORY message, 89
P
PAPER OUT message, 87
parallel port
characteristics of parallel connection, 25
connection and configuration, 27
connector location, 16
setting parallel communications, 63
parity setting, 64
passwords
default, 50
disable, 50
entering, 50
setting password level, 72
PAUSE button
description, 19
FEED and PAUSE self test, 102
PAUSE self test, 98
Peel-Off mode
cleaning peel-off assembly, 82
loading media, 36
media path, 35
print mode use described, 34
perforated media
described, 31
power
connect to power source, 29
power cord specifications, 30
power switch and connector locations, 16
site selection, 24
Power-On Self Test (POST), 96
print configuration label
CANCEL self test, 97
List Setup command, 61
print darkness setting, 54

Zebra ZM400 Specifications