Zebra ZT600 Series Installation Instructions

ZEBRA and the stylized Zebra head are trademarks of Zebra Technologies Corporation, registered
in many jurisdictions worldwide. All other trademarks are the property of their respective owners.
©2019 Zebra Technologies Corporation and/or its affiliates. All rights reserved.
P1086089-003
5/8/19
Applicator Interface Option/Maintenance Kit for
ZT600 Series and ZT411/ZT421 Printers
This kit includes the parts and documentation necessary to install the Applicator Interface
Option/Maintenance Kit in the ZT600 Series and ZT411/ZT421 Printers.
Read these instructions thoroughly before installing this kit.
Parts List
Before proceeding, verify that your kit contains the items for your printer listed in Table 1
below.
Figure 1 • Kit Contents
Caution • A qualified service technician must perform this installation.
Table 1 • Parts List
 Item Description Qty
Ref
ZT600 Series and ZT411/ZT421 Printers Applicator Interface
Option/Maintenance Kit
1
1
Applicator Interface 1
2
Hexoglobular Screw, M3 × 6 2
To reorder specific parts, navigate to http://www.zebra.com/parts, and select your printer model.
1
2
2

Zebra ZT600 Series Specifications

General

Print Method	Thermal Transfer/Direct Thermal
Print Resolution	203 dpi/8 dots per mm; 300 dpi/12 dots per mm
Maximum Print Width	4.09 in./104 mm
Maximum Print Speed	14 ips (356 mm/s) for 203 dpi, 12 ips (305 mm/s) for 300 dpi
Media Sensors	Reflective and Transmissive
Communication	USB, Serial, Ethernet, Bluetooth
Memory	512 MB Flash
Operating Temperature	5°C to 40°C