Zebra ZT600 Series Installation Instructions

13
Applicator Interface Option/Maintenance Kit for ZT600 Series and ZT411/ZT421 Printers
Remove the Old Option Card or Cover Plate
5/8/19 P1086089-003
Remove the Cover Plate
1. See Figure 11. Remove the blank cover covering the top slot by removing the two
mounting screws.
Figure 11 • Remove the Blank Cover (ZT600 Shown)
2. Go to Install the New Applicator Interface onpage14.
1
Blank cover
2
Mounting screws (2)
1
2

Zebra ZT600 Series Specifications

General

Print Method	Thermal Transfer/Direct Thermal
Print Resolution	203 dpi/8 dots per mm; 300 dpi/12 dots per mm
Maximum Print Width	4.09 in./104 mm
Maximum Print Speed	14 ips (356 mm/s) for 203 dpi, 12 ips (305 mm/s) for 300 dpi
Media Sensors	Reflective and Transmissive
Communication	USB, Serial, Ethernet, Bluetooth
Memory	512 MB Flash
Operating Temperature	5°C to 40°C