ZENEC ZE-NC520 - Auto Store (As); Program Scan (Ps); Seek the Pty; Af Function

96
Recalling a station
1. Select a band (if needed).
2. Touch an on-screen preset button (6) to select the corresponding stored station.
AUTO STORE (AS)
■ Press the AS/PS button on the panel or Press and hold the
B button on the screen to
automatic scan and store strong radio stations in the 6 preset channels in the current
band.
PROGRAM SCAN (PS)
1. Press and hold the AS/PS button on the panel or press the B button on the screen.
Scan the stations in the 6 preset channels in the current band.
2. Touch the
K
button on the screen to automatically scan all stations in current band to
preview stations.
3. Press any button to stop scanning and listen to the selected station.
SEEK THE PTY (Program Type)
■ Touch
[
in the screen to enter PTY menu, then touch to select one in the PTY menu,
the unit will auto seek the next available PTY by increasing tuning frequency until the
program type matches the PTY, if no match is found, the tuner will return to original radio
and “None” is displayed.
AF FUNCTION (Alternative Frequency/Auto Following)
■ Touch
[
in the screen to activate/deactivate AF function. When AF is activated and
a radio signal is too weak, the tuner automatically switches to the best alternative
frequency.
 NOTE:
■ During auto switching radio frequency, some interference can eventually be heard. Turn
off AF function can cease this issue.
TA FUNCTION (Traffic Announcement)
■ Touch
\
in the screen to activate/deactivate AF function. When TA is activated, the
unit will auto seek an available TP or TA station .After the seeking, no matter if PTY was
found, the tuner will auto seek each station for 1 minute.
■ When TA is activated and a traffic announcement is received, the current playing source
is overridden by the traffic announcement automatically, if the tuner was last set to the
FM band but not if it was last set to the AM band. When traffic announcement is over,
the current playing source will be resumed.
REGION
■ When AF and Region are activated, Auto tuning to those stations within the region is
assigned. When AF is activated and Region is deactivated, Auto tuning to attempts to
find stations without any region boundary.
MONO
■ When monophonic function is activated, the tuner automatically switches to mono
mode. If monophonic function is deactivated, the tuner automatically switches to mono
mode and stereo mode.