circumstance – the ballast will maintain the last dimming value that may have
been set.
Some lamps may implement a significant delay when they are switched on.
Such circumstance must be taken into account in case of parameterising timed
actions or flashing and dimming sequences.
The ability to report ballast errors will depend on the ballast itself. The
documentation provided by the manufacturer should indicate whether such
functionality is available or not.
There may be some other (minor) particularities depending on the ballasts and on the
lamps in the installation. Therefore, the integrator is advised to perform some testing to
ensure compatibility.
Recommendation: it is advisable to install only one ballast type within the same group
in order to avoid ballast control issues.
To Next Page