Zennio DALIBOX Interface 64/32 - Status Objects

DALIBOX Interface 64/32
http://www.zennio.com Technical Support: http://support.zennio.com
40
2.5.5 STATUS OBJECTS
DALIBOX Interface 64/32 provides different objects that report the current dimming state
of the output group:
A one-bit object (On/Off).
A one-byte object, which indicates the dimming level (in percentage).
ETS PARAMETERISATION
After enabling this function, the following options will be available in the “Status Objects”
tab:
Figure 17. Status Objects
Send On/Off Status [enabled/disabled]: enables sending a one-bit object
(“[Group n] On/Off (Status)”) whenever the group is switched off (“0”) or on
(“1”).
Send Dimming Status [enabled/disabled]: enables a one-byte object
(“[Group n] Dimming Value (Status)”) that will be sent with the current
dimming value of the group (between 0% and 100%) whenever it changes.
Enabling this parameter brings up an addition one:
➢ Sending Period [0…255] [s]: defines the sending cycle time of the status
object during a dimming process. If it is set to “0”, the dimming status will be
sent only at the end of the dimming process.