2.8 DISPLAY
2.8.1 MAIN MENU
DALIBOX Interface 64/32 incorporates a 128x64 pixel display together with six
additional buttons to browse through the options it shows.
During normal device operation of the device, the screen remains off to save power.
Pressing on a button (arrows, OK or ESC) will activate it back and show the main menu.
After a minute without further interaction, it will turn off again.
This main menu (i.e., the upper level) includes a list with the following options:
1. Installation
2. ECG Detection
3. Switch All ECGs
4. Reset All ECGs
5. Manual Control
6. Scene Control
7. Burn-in Control
8. Application Version
It is possible to browse through them by pressing on ▼ and ▲. To enter any of the
submenus, please press OK. To return to the previous menu, please press ESC.
Note: if a power supply failure or a short-circuit error takes place, the display will switch
back to the upper menu in case any of the submenus has been opened. A “Bus Error”
message will be shown if trying to open any submenus until the error is over.
2.8.2 INSTALLATION
This submenu allows performing the following actions, which may be useful during the
installation of the DALI system or during later maintenance:
Testing the ECGs present in the DALI bus.
Identifying tor modifying the addresses of the ECGs detected.
Identifying or modifying the group assignment of each ECG.
To Next Page
Loading...