2.3 ENABLING GROUPS
Any group containing at least one ballast (or that may contain it after later assignments
performed via the display of the device) must be explicitly enabled. Moreover, this makes
it possible to configure the desired functions for each group, as described in section 2.5.
ETS PARAMETERISATION
The “Enable Groups” tab allows enabling each of the groups that may be or may have
been assigned to the ballasts.
Figure 11. Enabling groups
One checkbox is provided per group. For each enabled group, a new tab named “Group
N” (N = 1 to 32) will be incorporated into the tab tree on the left. Please refer to section
2.5 for details.
To Next Page
Loading...